asked
After replacing the display module on my JennAir JDS9860BDB Dual-Fuel range, the touch board functions for about 30 seconds and then stops. If I unplug the ribbon connector and plug it back in, the touchpad works again for about 30 seconds. If I touch a short series of buttons while the touch panel has stopped functioning, then unplug/replug the ribbon connector, the display will run through those commands. The ribbon looks okay. What could be causing this issue and what can I do to fix it?
December 1st, 2024
We have a Whirlpool microwave model # WMH32517AW. It has been working fine until the last attempt to use it. No matter the settings, it only runs for 2 seconds. I have tried various settings but it still only runs for 2 seconds. What could be the issue and what can I do to fix it?
July 16th, 2023
I washed some pillows in the machine and it started today. How long has this been going on? What have you tried so far? Anything else we should know to help you best?
December 12th, 2023
My Frigidaire dryer, model LEQ7000ESO, shuts off before finishing any drying cycle, displaying an 'err' code or just shutting off after running for 5-10 minutes. I have tried resetting the breaker and using different cycles. What could be causing this issue?
February 8th, 2024
Why is there water building up in the bottom of my refrigerator?
July 15th, 2024
My KitchenAid refrigerator (model KBF A25ERSS) is randomly warming up and not starting back up after reaching the proper temperature. This happens about once a day. The freezer reaches 0°F and the cabinet reaches 38°F, but it warms to 48°F before cooling back down. I have cleaned the refrigerator for good airflow over the coils, bench tested the evaporator motor, and tested the capacitor. I am convinced the compressor and fans are not the issue, but I can't figure out why it doesn't come back online after reaching the thermostat setting. Shaking the refrigerator upon pushing it back in place seemed to start it up, but it might be a coincidence. What could be the issue?
June 18th, 2024