Wesley N. asked
Hi, all the igniters are clicking even with the knobs off. The appliance is a Five Star TTM510-BW. I have tried disconnecting the switches one by one. The igniter module was changed at some point, and I got the stove used. What could be the issue and what should I do?
December 5th, 2024
Kerry M. answered
The continuous clicking of all the igniters without any of the burner controls turned on typically i...
December 5th, 2024
Create an account to view answers and interact with the community!
Hi, I have a Bravo XL washer and the spin cycle sounds like a plane taking off. Does this mean the bearing is going out? It doesn't matter what spin speed it's set at. What can I do?
July 25th, 2023
How do I reset or remove the hourglass symbol on my Samsung Model DV409AGW/XAA gas dryer so I can use the dryer? What steps do I need to take to make it operational again?
April 2nd, 2024
Hello, I have a Maytag MHW6000XW front load washer that won't drain, keeping the door locked. The error code is E01, F09, indicating slow or no drain. I've tried resetting the machine by unplugging it, but it won't reset this time. I've checked and cleaned the trap, inlet tube to the pump, internal and external drain hoses, and the hose to the pressure switch, all of which were clear. The pump's impeller could be rotated by hand and ran fine when tested with line voltage. What can I check next or what would be my next move?
January 17th, 2024
I need the wiring harness for my Crosley dishwasher (Model XDF300PGN4WW01, Serial RR746437B) that is under warranty. The dishwasher was purchased on 09/26/20, and the wiring harness is defective. The board and pump have already been replaced. The appliance is currently at McCammons Appliance Repair in Newport, OR, an authorized repair center for GE. How can I get the wiring harness replaced under warranty?
January 4th, 2024
Each time I press power, the screen shows LOC with a red key sign and turns off. The washer is less than a year old and just started doing this. We just added detergent to the Load and Go Bulk dispenser for the first time. Could this be the issue?
February 10th, 2023