asked
I am new to appliance repair and have two freezers with cooling problems. Both have clean evaporator and condenser coils, working compressors but hot, functioning condenser fans, good start relays, and good compressor windings. The current flow is around 0.7 amps, but there is not enough cooling in the freezers or fridges. The freezers are around 5 years old, one is a Maytag and the other is a Kenmore. What could be the issue, and is it common for low gas pressure to happen suddenly? Could there be a restriction in the copper tubes, specifically the capillary tube?
September 23rd, 2023
One red light on my Whirlpool Accubake oven stays on even though the oven and stove top are off. I have tried turning off the breaker but it still comes back on and stays on when I turn the breaker back on. What could be causing this and how can I fix it?
August 25th, 2024
I have a Maytag dishwasher model MDB4409PAS0, about 6 1/2 years old, and the control panel has been malfunctioning for a few weeks, getting worse. The select options buttons (high temp-wash and rinse, dry heat, and 4-hour delay) are not responding. I tried resetting the dishwasher by unplugging and replugging it, but it didn't help. What could be the issue and what can I do to fix it?
July 2nd, 2024
There is frost buildup on the outer front of the freezer compartment of my Whirlpool model WRS315SNHW01, which I purchased on 10/17/2019. This issue has been ongoing for about a week, and I haven't tried anything to resolve it yet. Is the door sealing properly?
July 13th, 2023
I have a Miele W1926 washing machine, 15 years old, which had its motor replaced 2 years ago. Now, the motor is not turning during the wash cycle. I unplugged and adjusted the wires connected to the motor, and it ran for one full wash cycle before the issue recurred. Do you have any suggestions on what might be causing this and how to fix it?
November 22nd, 2024
My Kenmore model #795.71033.010 refrigerator is not cooling at all. The compressor and both fans are running, but the compressor is hot to the touch, and there is no frost on the evaporator coils (freezer), just a bit of condensation. What could be the issue, and how can I determine if it's low on freon or if the compressor is bad?
March 5th, 2024