asked
I have a 2001 Mod #52544101 Kenmore refrigerator and want to replace the water dispenser lever and ice lever. Does the front cover housing just snap off? I pulled on it and it feels tight in the corners.
June 16th, 2024
I have a Kenmore gas dryer, less than 6 months old, that goes off during the drying cycle and displays code LE1. The dryer vent has been repiped with 12' of 3" hard duct and 2' of flex duct. Air comes out at the discharge end of the pipe. The dryer beeps three times just before it goes off. Cleared the back side to ensure clearance for air. Model 796 91172210, Serial 302KWPVA512. What could be causing this issue and how can I fix it?
October 29th, 2023
I have twice replaced tub gaskets in two different dishwashers. Over time, 'crud' builds up on and behind the gasket, likely from material suspended in the wash water. Should I periodically remove the gasket and clean it and the track it slots into, and if so, what would I use as a cleaner; or should I continue to just replace the gasket every three years or so?
October 2nd, 2024
My refrigerator's freezer temperature rose to 21 and won't reset to 0, the recommended temperature. What could be wrong?
September 3rd, 2024
I have a GE Profile electric dryer (Model PTDS650EM0WT) that is not heating. I have changed the heating element and verified all thermostats and thermistor. Could it be the main board? Voltage is 240 verified.
August 1st, 2024
We replaced the motherboard in our fridge, but when we put the program code from inside the fridge into it, it just beeps instead of flashing. What could be the issue and how can we resolve it?
May 21st, 2023