Rodney J. asked
I have a Bosch SHE3AR56UC/07 dishwasher that stopped in mid-cycle and the control panel lights never came back on. I've checked the power source, replaced the door latch sensor, and tested the on/off switch, all to no avail. Should I replace the electronic control board in the handle or the power unit at the bottom right under the tub, and is there a way to test these parts before ordering them?
May 30th, 2023
Christopher M. answered
Without power to the dishwasher, there's no way to test the electronics effectively. Given the troub...
May 30th, 2023
Create an account to view answers and interact with the community!
There is a smell coming from inside the refrigerator, near a small vent at the top. The vent appears to be frozen. What should I do to address this issue?
April 24th, 2023
My oven has locked during regular cooking and showed an F3 and E2 code. We have turned off the power but it is still locked. What happened just before your oven displayed this message? How long has this been going on with your oven? What have you tried so far? Anything else we should know to help you best?
April 28th, 2024
We have a European-sized dishwasher, older model, with dial control. It has recently started to not run consistently on the 'Water Miser' setting or most other settings on the dial. It hums from the motor area. How can I determine if the issue is multiple dead spots on the dial, the motor, or a relay?
January 15th, 2024
Hi, I have a front loading Samsung washer model WF350ANW that makes a very loud noise when it goes into the high speed spin. This is in a normal wash cycle or extra rinse cycle. The timer on the washer will show 5 minutes, the timer stalls for a minute or two and then shows 1 minute and the clothes aren't wrung out like they should be. Just started over the last week or so.
February 6th, 2023
My GE Monogram range with double oven keeps displaying 'probe' on the screen, even though it was beeping but has now stopped. The oven appears to be working correctly. I am leaving town tomorrow and would like to know if something is wrong and can be dealt with when I get back.
April 5th, 2023
