Jamie W. asked
I have a gas Maytag Dryer - LDG9304AAM. The igniter glows and the gas ignites on startup but shuts off after a minute or so. I have checked for continuity on the igniter, fuse link, flame sensor, high limit thermostat, and cycling thermostat. I suspect the gas valve solenoids are okay because it lights on initial startup. I also checked for continuity on the igniter. I have continuity on all the items mentioned above. I checked for good airflow and replaced the blower, which was worn on the shaft. The exhaust air seems good to the outside vent, but I removed the duct work from the back of the dryer and ran it with the front door in place to ensure good airflow. Still, no continuous heat, just on startup for a few minutes. What could be the issue and what else can I check?
May 3rd, 2023
Jennifer H. answered
The issue is likely due to the solenoids on the gas valve. The igniter does not grow weak on these m...
May 3rd, 2023
Create an account to view answers and interact with the community!
I have error codes F3 E1 on my Whirlpool front load washer, model WFW75HEFW, purchased in Nov/2016. The washer began beeping with these error codes during a Quick Wash cycle, and the door is locked. I have an extended warranty until Nov/2019. How can I manually unlock the door and troubleshoot the pressure switch issue to potentially avoid needing a repairman?
April 27th, 2024
We have an LG dryer that is giving an error message related to flow sense, indicating no obstruction in the ventilation, but the message keeps popping up. Is there a sensor to replace or a way to reset it?
February 2nd, 2024
I have a WED5820SWO dryer that runs but does not heat. I bypassed the thermal fuse and it still does not heat. What can I try next?
August 6th, 2023
My Whirlpool convection oven/microwave won't get hot. The control panel works, the fan works, the microwave works - everything works except it won't get hot. This happened right after we ran the self-cleaning feature which worked. The broiler won't work. It is model # XXXXX. What could be the issue and how can I fix it?
September 27th, 2024
I have a Maytag dryer model SDE515DAYW. The idler pulley was squeaking, so I changed it. After reassembling the dryer, it only runs for 10 seconds and then cuts off. The inner drum turns normally by hand, and the motor was replaced today. What could be causing this issue?
December 27th, 2023
