asked
I have a Harmon P61 pellet stove that has been running cooler than it used to, even on its highest settings. I have cleaned the stove, flue, and ESP probe, and the burn pot holes are clear. The flame is active and not lazy, and I've been using the same brand of pellets for three years. The temperature has been down for about three weeks, and I've tried a new thermometer which shows the same results. What could be causing this issue and what else can I check?
July 12th, 2024
We have a Miele 851 SC dishwasher. Every other time it runs, the Top Solo light is lit when the cycle is over (though we set it for Normal cycle) and the dishes don't dry all the way. When it runs all the way through and the Top Solo light is not on at the end, the dishes are dry. What could be the cause and solution for this issue?
March 14th, 2023
My Thermador Slide-In RES30, installed in March 1999, has developed a problem with the oven heating system over the past two weeks. Neither the 'bake' nor the 'convection' cycles will heat past about 200°F. The 'Broil' cycle works fine. I ran the oven test to see if the thermostat was off calibration, but the results were inconclusive. What can you suggest?
May 1st, 2024
I need to replace a Whirlpool combination microwave wall oven (model RM778PXT, serial # XXXXX, manufactured in 9/1988) and need the specs/dimensions. I want to replace it with a Kenmore microwave wall oven (serial # XXXXX, manufactured in 2000). Will the Kenmore model fit in the place of the older Whirlpool model?
August 26th, 2024
I was cleaning my oven (model CPTS227 & CPTS230) and after wiping down the interior and removing the fan screen, the oven became inoperative. Red 'OFF' lights now appear in the upper corners of the readout screen. What can I do to fix this without calling a local service man?
November 22nd, 2023
I have an 80 qt. Hobart mixer. Recently the clutch has become difficult to engage. It does eventually go into place and works fine. Is there anything I can do to fix this without paying for a service call?
February 10th, 2024