asked

I have a Kenmore dryer 417.84052500 that would not go into diagnostic mode and had an E9E error code. I replaced the control board. Now, you can go into diagnostic mode, but the drum only turns 1/4 turn and then quits. Power and ground to the outlet are good, and the wiring from the power cord to the dryer is good with no loose wires. What is wrong here?

June 24th, 2023

Sign Up to View Answers

Create an account to view answers and interact with the community!

Related Questions

We have a GE bottom freezer refrigerator, 3 years old. The motor runs but the freezer, set for 0, is now reading 4 and holding after reading -1 this morning. The refrigerator, set for 37, is now reading 63 after being 61 this morning. The refrigerator started getting warmer over 24 hours ago. We went through the troubleshooting guide in the manual but couldn't find an answer. We turned the system off and then back on using the set buttons, but it didn't solve the problem. Is there anything we missed using the manual to try to solve the problem? What might the problem and solution be?

May 27th, 2023

My Bosch dishwasher model #XXXXX, serial #XXXXX, is not cleaning dishes properly. If using dishwasher magic doesn't help, what should I do?

June 24th, 2023

I have a built-in ESL63010 Electrolux dishwasher that is not heating the water and is not cleaning properly. I am familiar with fault-finding processes and presume the appliance has a temperature control thermostat and possibly a high limit cut-out, either automatic reset or manual reset. Could you please inform me of the likelihood of which it would be and, if manual reset, the location? I also suspect it could be a burnt-out heating element or the main programming device. The appliance is approximately 18 months to 2 years old.

July 24th, 2024

My LG fridge displays an error code ER DH, runs constantly, and has inconsistent temperatures. The freezer is frosting up, and no ice is being made. Unplugging the unit temporarily resets the issue. Is this indicative of a main PCB failure or a defrost heater element failure?

December 15th, 2024

How do I install an actuator part (water side) for a Kenmore refrigerator?

April 19th, 2024