Robert A. asked
I have a Kenmore front load washer model 49057 that has excessive run time, getting held up at certain times during the cycle, especially around the 20-55 min mark (drain and spin). The pump filter has been cleaned regularly, no fault codes have been displayed, and all hoses and elbows have been cleaned. The unit is level and sitting on concrete with no wobble. What could be causing this excessive run time?
September 17th, 2023
Michael J. answered
The excessive run time in your Kenmore front load washer is likely due to either a damaged impeller ...
September 17th, 2023
Create an account to view answers and interact with the community!
My Sharp Drawer style microwave KB-6525P has a power cut out. The circuit breaker is not tripped, and the outlet is working. Is there a fuse in this model, and is replacing it difficult?
March 2nd, 2024
I have a Whirlpool Duet Front load washer with error code F3 E2. The door will not unlock, and I cannot access the model number/serial number. The washer is only 1 year old. What could be causing this issue and how can I fix it?
February 7th, 2023
Where is the heating element located in my dryer, and how can I access it to replace it if it's not working?
December 20th, 2024
I need help with a Maytag commercial washer. The model number is *****, and I have an error code ERR 10 BIN/SPRING (D17). Do you provide assistance for this issue?
October 5th, 2023
I have a Samsung refrigerator, model RM255, with non-functioning fans in both the upper freezer and refrigerator sections. I have replaced the thermostat, main control board, and temperature sensor, but the fans still do not run. I have also swapped the fans to check for a bad motor or circuit, but neither fan runs. What power should I use to test the fan operation, and is there a specific part or issue I should focus on to resolve this problem?
January 30th, 2024