Shannon G. asked
I have a Kenmore HE3 dryer that keeps blowing the thermal cut-off. I've cleaned the duct, replaced the thermostat, and the heating element, but the issue persists. What could be causing this and what steps should I take to diagnose and fix the problem?
December 1st, 2024
David C. answered
The issue could be due to a grounded heating element, a clogged vent, or a malfunctioning control bo...
December 1st, 2024
Create an account to view answers and interact with the community!
When I turn on my dishwasher, it stops and the red light says 'water tap' and it won't run. What could be the issue and how can I fix it?
August 28th, 2023
I have a Samsung DMT300RFW dishwasher with heavy and quick lights flashing. I replaced the water fill sensor but the error persists. What should I try next?
October 15th, 2023
My dishwasher starts to fill then leaks all over the floor. We replaced the water valve because water was not flowing, but now the water flows but leaks all over the floor. I am thinking we need new water hoses but am not sure what parts to order. Kitchen Aid model KUDS02FRBL2.
June 27th, 2023
I have a Kenmore dryer that is getting too hot. Even when I change the setting to air dry/no heat, the heating element still comes on. Model 110.66982500. What could be causing this issue and how can I fix it?
January 27th, 2024
I removed the control board from my 10-year-old gas oven (model CWG3600AAB) to send it out for repair, but I didn't take a picture of the wiring before removing it. Now that I have the repaired board back, I don't know where the five wires go. Can you help me identify the correct wiring configuration for the control board?
December 29th, 2024
