Amanda S. asked

🔌  Appliance

I have a Liebherr fridge with a freezer that is not freezing properly, only keeping food cold but not 'stone cold.' The temperature doesn't decrease when set to the minimum, but it does if I decrease the temperature by 2 degrees periodically. Frost is accumulating inside the freezer back wall, and the temperature goes up instead of down when I remove the frost. What could be the issue, and what steps can I take to resolve it?

January 1st, 2024

Deanna R. answered

The issue is likely due to a problem with the defrost cycle, which is not happening correctly, causi...

January 1st, 2024

Sign Up to View Full Expert Answers

Create an account to view answers and interact with the community!

🔌Related Questions

I have a GE PS960YP3FS electric oven with a Fault 350 issue. The oven faults when pre-heating due to the cooling fan RPM being lower than 200. I have replaced the cooling fan, the RC17 relay control board, and two cooling fan sensors. I also tried replacing two other boards. The issue persists. What else can I try to resolve this problem?

July 11th, 2024

My Decor electric oven won't turn off. It's about 18 years old and I had to replace the control panel about 8 years ago. How can I fix this issue and who can repair it in St. Louis, MO?

August 15th, 2024

I just installed a new Bosch SHEM3AY55M dishwasher and it starts up but then flashes an E21 error code. I've checked for kinked or blocked drains, blocked inlets, and the water supply is on and flowing with good pressure. What could be causing the E21 error and what should I check next?

April 24th, 2023

What is a low DC alarm when running on electric, and how can it be resolved for a refrigerator in an RV that is about 11 years old with freezers working but not the fridge, and receiving a Lo dc message?

January 11th, 2023

My LG washer (model WM3670HWA) is displaying a recurrent OE error. The wash cycle runs for about 30 minutes, then the OE error comes on with significant water in the tube. I have drained the water, cleaned the filter, and reset the washer by unplugging it. This issue occurred last month and stopped, but it has been happening consistently for the last three days. What could be causing this and what should I do?

March 27th, 2024