asked

I have a Maytag commercial washer, natural gas, with an error code 'heat relay latched 1' on starting a cycle. I have the parts and service manuals but can't locate the heat relay. I suspect it might be related to the solenoid on the gas valve. The machine won't start a cycle and immediately shows the error. What could be causing this issue and how can I troubleshoot it?

April 25th, 2024

Sign Up to View Answers

Create an account to view answers and interact with the community!

Related Questions

After replacing the sensor in my LG refrigerator (model LFX25976ST/00), the freezer temperature dropped to -10 degrees, but now items are thawing. There was ice on the fins when I checked inside the freezer. What else can I check, and what could be causing the issue?

January 16th, 2024

My Maytag MHW5500FW1 washing machine, which is new (purchased 8/22), plays electronic songs and stops instead of washing laundry. This issue has been ongoing for at least 4 months. I have tried unplugging it for various durations (1 hour to 24 hours). The prior Maytag we owned exhibited similar behavior and required a humidity panel and main computer board replacement. What could be causing this issue and what steps should I take to resolve it?

April 26th, 2023

My refrigerator is not dispensing water and ice, only dispenses water when I unscrew the water line and spit some water out and rescrew it back in, but only for a few hours and then stops again. I hear humming or buzzing when trying to get water or ice. This has been going on for the last 2 weeks. I've tried a factory reset on the ice machine and used a heat gun on the water line at the bottom of the fridge. What could be the issue and what should I do?

February 14th, 2024

My Amana appliance (model NFW5800HW0) won't get off lock. The lock light comes on when I push start. What should I do?

February 23rd, 2023

My LG refrigerator (model LFC25776st, 2013) is not cooling properly. The freezer and fridge are not cold enough, the compressor is running, and there are no LED error codes from the diagnostic test. The condenser coils are clean, and air is coming out from the vents but not cold enough. What could be the issue, and what steps should I take to diagnose and potentially fix the problem?

April 4th, 2023