asked
I have a Maytag Neptune Super Stack SL-3 with an issue where it does not perform its high-speed spin extraction at the end of any of the three wash cycles. Instead, it performs a low-speed spin in both directions, similar to the rinse cycle. Is this a motor control board issue, and if not, what other components should I check or replace?
February 26th, 2024
My LG washer is flashing “CL” on the display. It started when I tried to do a tub clean. I cleaned out the water from the tubing and the lint from the filter. What does 'CL' indicate, and how do I turn off the control lock?
February 15th, 2024
I have a Samsung washer with a TE code. The sensor has been replaced, but the code is still there. Any suggestions?
November 15th, 2024
My Samsung oven is displaying a C-D1 or C-DL error after self-cleaning. This has happened before, and I can't remember how I fixed it. What should I do to resolve this issue?
December 10th, 2024
How to install the ice dispenser lever on a GE Monogram refrigerator model ZISS480DXBSS?
July 23rd, 2023
I have a Fisher & Paykel dishdrawer that was running when a power outage occurred. When the power returned, both drawers began running and the code 'F1' began flashing in each display window. I had to turn the power off to stop them. The manual states that the water and power supply needs to be turned off and that our authorized service center needs to be called. I don't know who our authorized service center is and I am located in northeastern South Carolina. Can you provide some guidance?
February 18th, 2023