asked
I have a new Blanco dishwasher BFD45X. It did not drain during the first cycle due to improper drainage pipe setup. After fixing the drainage pipe, the machine drained but did not finish the cycle and made a low humming noise. Now, when starting a new cycle, the machine only hums and does not wash. I have tried turning it on and off and holding the pause button for 3 seconds to change the cycle setting, but it always returns to the humming noise. How can I reset the machine or fix this issue?
June 18th, 2023
I just finished baking and noticed the bottom heating coil is broken in three places and the surfaces of the entire oven, door, racks, and dish are covered with a fine white powder-like substance. Can the coil be replaced and what is the white powder? Is it safe for food? I am just beginning my Thanksgiving baking and am devastated.
December 5th, 2023
I have a Kenmore Elite stove model C970-692621. I received an error message `LOC` and the oven is not working. How can I resolve this issue?
November 4th, 2024
I have a 2001 Kenmore front-loading washer made by Frigidaire. The drum motor does not operate during agitation or spin modes. I have replaced the motor controller board, the motor, and the timer switch assembly, but the issue persists. None of the troubleshooting steps in the manual have revealed the cause. What else can I check or consider?
January 28th, 2024
My Fisher Paykel GWL 11 lid lock light is not coming on, and it won't spin and agitates very slowly. I just replaced the module and pump and reset the machine size. Is this an electronic setting or a manual/hardware problem? Thanks for the help.
November 22nd, 2024
I have a Maytag Neptune MDG5500AW Gas Dryer. Over the last two months, various lights on the front (including the power button) have been flashing, and now I can't get it to start. The lights flash when I plug it in, but pressing the start button does nothing, and I can't change any settings. What parts do I need to replace?
December 24th, 2023