asked
I have a Norcold fridge model N841 that won't exit diagnostic mode. I've tried all combinations and even put it on 6 for ER, but when I push temp, it doesn't clear. What should I do?
March 14th, 2024
I have a Maytag LTF2112AR Refrigerator/Freezer. The freezer compartment has ice forming over all items and icicles hanging from the top. I completely shut it off (unplugged it) and took all items out for a period of hours, but it started doing it again within a couple of days. What could be causing this and what should I check?
April 23rd, 2023
I have a T36BT820NS fridge. After defrosting, there is an '@' symbol above the freezer temperature readout (just above the 'F'). The Super Freeze option is on, but there is still no ice after 48 hours post-defrosting. The fridge part seems cold enough, but the freezer is not as cold as expected, with the temperature reading -22F. What does the '@' symbol mean, and what should I do about it?
October 13th, 2024
I recently moved into a purchased home in Sedona, Arizona which had an under-counter U-Line Ice Maker refrigerator combo in the den. I found that it is not functioning and would like it repaired. Is there a technician in Northern Arizona (Flagstaff or Prescott) who might be able to competently service this unit?
July 13th, 2024
I have a Kitchenaid dishwasher model KUDP01DLWH6 that has stopped working. The clean light blinks 7 times, pauses, and then blinks 7 times again. I tried a reset sequence but it didn't work. After resetting, the dishwasher cycles through but ends with the same 7 blinks error. Additionally, the sprayer arms are not spraying or spinning during the cycle, and the bottom spray arm rotates roughly. There seems to be a heavy build-up of soap or calcium in the bottom of the washer. What should I do?
June 30th, 2024
Kenmore dishwasher model 665.13929K010 runs through any cycle until it gets to the soap drop, then it runs for 3-4 minutes, goes into cancel mode, and shuts off. This issue started with the normal wash cycle and has persisted through other cycles. I replaced the program module, which worked part of the time, but the problem returned. I am currently running the smart cycle, which seems to be working. I believe there might be a sensor issue affecting all programs. Can you help diagnose the problem?
October 12th, 2023