asked
I have a problem with my KitchenAid refrigerator. The display shows 'off' and the lights stay on. When I press the on/off button, it works fine for about two hours and then shuts down again with the display showing 'off'. I replaced the board in the back, which worked for a week, but the issue returned. Unplugging and plugging the refrigerator back in temporarily resolves the problem, but it stops working again after a short time. What could be causing this issue and how can I fix it?
June 23rd, 2024
I have a Whirlpool microwave, model Mwh31017aw-2, with a serial number TRW2285611, which is about 1-2 years old. The magnetron has stopped working, and I want to check on the warranty coverage. I have home warranty insurance and need to decide whether to repair or replace the microwave.
December 19th, 2023
We have a Maytag top load washer - model MVWB755DWO that we purchased in 2015. We have always had an issue when washing sheets on the bedding cycle where it never spins out, requiring us to manually select the rinse and spin cycle. We recently had a repair tech replace the control board and a lid switch mechanism, but the issue persists. Why would Maytag knowingly make a product that does not spin out at the end of the bedding cycle, and do you have any advice on how to resolve this issue?
December 19th, 2024
My Panasonic washer model NA 140VS4 has an issue where water gets stuck inside after using cold wash. The door can open after another cycle, but water remains inside. What should I do?
March 19th, 2024
My Samsung dishwasher (model DW80F600UTS) stays in wash mode all night and doesn't clean the dishes. It occasionally opens the soap dispenser but usually doesn't advance in the cycle, and the water only gets warm. What could be causing this issue and what steps should I take to diagnose and fix it?
August 9th, 2024
I have a GE Cafe CGS985SET6SS gas oven that has never worked correctly since installation. It sometimes beeps right away when preheating, and other times it reaches temperature and turns off on its own. The electric control panel and thermo probe have been replaced, but the issue persists. What could be causing this erratic behavior, and what steps can I take to diagnose and fix the problem?
March 4th, 2023