asked

I have a RM770PX AQO oven. The control board works, but the oven will not heat. The broiler also does not work. The clock is okay, but the temperature increments are not right—sometimes increments of 100. What do I need to replace?

December 16th, 2023

Sign Up to View Answers

Create an account to view answers and interact with the community!

Related Questions

I have an issue with my Whirlpool top-load washer. It won't wash; it only runs for a couple of seconds and then stops. I checked the lid switch and bypassed it, and the washer spins OK, but it still won't wash. Why won't it wash at any cycle?

March 7th, 2023

I have a Kenmore 596.76593600 French door style refrigerator that has been getting warmer in both the freezer and fresh food compartments over the past few days. The digital readout shows 38 in the freezer and 52 in the fresh food section. The condenser coils are clean, no frost on the evaporator coils, and both the evaporator and condenser fans are running. The compressor is also running but the copper tubes connected to it are not cold. What could be the issue and is there a way to diagnose or fix it?

June 24th, 2023

I have a Thermador warming drawer, either model WD27 or WD30. The seal just inside the drawer has been pulled out in 2 sections and I am looking for the best way to put them back in.

March 21st, 2024

My Whirlpool dishwasher model number WDF750SAYB3 fills with water but does not run after that. I hear a bunch of clicking sounds from the control panel area but nothing ever happens. It eventually drains. I bought it a year and a half ago and had to replace the control board after just one year. Now, less than a year from that repair, this issue is happening again. What could be the problem and should I consider replacing the dishwasher?

January 8th, 2024

I have a 29cf Whirlpool French door fridge, model WRF989SDAM03. The fridge's evaporator was replaced by another tech, but they melted the 3-way valve. I replaced the valve myself, evacuated and recharged the system. The fridge is now functioning well, but it won't dispense water or make ice, and I can't access the measure menu on the front panel. All icons stay lit up, and there are no error codes. I replaced the front control panel, but there was no change. What could be the issue?

February 3rd, 2024