My Maytag Neptune front-loading washer stops during the wash cycle, makes a low buzzing sound around the rinse cycle, and unlatches the door. I have found a fluorescent plastic pull that looks pinched off and the machine seems to be on a constant wash cycle. What could be causing this issue and what steps should I take to diagnose and fix it?

February 1st, 2024

Kenmore Washer model #110.28837700 does not agitate. I have replaced the agitation board and the water level switch. What could be the issue and what should I check next?

March 13th, 2024

My Whirlpool Fridge ED22DSXEN00 (1996) suddenly stopped working properly. There are no interior lamps, and the evaporator fan only runs when the door is opened, causing improper cooling. I have replaced the defrost bi-metal, cold control, evaporator fan motor, and adaptive defrost control, but the issue persists. The compressor runs well but supplies only 80 volts to the evaporator motor leads when running, and 120 volts when off. The compressor overload and start relay, and compressor terminals all check out within tolerance. What should I check next?

May 4th, 2024

Good morning. I have a question about my Whirlpool WED8300SW2. I replaced the interface board due to an F-01 error, but I believe I may have replaced the wrong part. What should I do next?

September 20th, 2023

I have a GE JVM3670SF001 over-the-range microwave. While boiling a large pot of water, the vent fan turned on by itself and then the microwave went dark, with no display. After unplugging and plugging it back in, it still doesn't work. Is it fried?

March 18th, 2024