asked

I have a Scotsman SCN60PA nugget Ice maker with a drain pump that now runs every 2 minutes for about 1 second, which is more frequent than its previous schedule of every 30 minutes to an hour for 3-5 seconds. The pump still works, but it's annoying for it to activate so often for such a short duration. What could be causing this issue and how can it be resolved?

May 26th, 2024

Sign Up to View Answers

Create an account to view answers and interact with the community!

Related Questions

My Whirlpool refrigerator W2RXEMMWB00 is not as cold as it should be. The freezer seems fine. Is there something I can do?

December 31st, 2023

My Maytag dryer series 3000 won't start. All over controls are lit up, even the light. The dryer worked yesterday, but it wouldn't work last night. I checked the fuses, plugged and unplugged the dryer, and believe the door switch works. How do I check it, and what else can I do to troubleshoot the issue?

April 15th, 2023

I have a Whirlpool washer model WTW4900BW1, serial C42333486, that isn't running the cycles properly; it gets stuck in stages. It either stays stuck in sensing mode or doesn’t wash or rinse, only spins. The washer is a top-load model and has been sitting unused for a while. What could be causing this issue and what can I do to fix it?

September 18th, 2024

My Maytag MBB2254GEW Bottom Freezer Refrigerator's freezer works fine, but the upper refrigerator is at 70 degrees. The compressor, fan motor, and fan are running when I open the back lower panel. There is a thin patch of frost on the upper back of the freezer. What could be the issue and how can I fix it?

June 15th, 2023

I have a GXSF30H GE water softener that is not filling the brine tank properly. I have cleaned the system, checked the float, and ensured the fill tube is clear, but the water level still stops at 1-2 inches. The float moves freely and the fill tube provides a good amount of water. The recharge process starts but stops after a few minutes, and the 'Recharge Now' light keeps flashing without further action. What could be causing this issue and what steps should I take to resolve it?

March 2nd, 2024