asked

I have a Whirlpool Cabrio WED6200SW1 Electric Dryer. The display is on and the timer works, but the dryer doesn't turn. I've replaced the Thermal Thermistor, Thermostat, Hi-Limit, Thermofuse, and Thermal cut-off, but the issue persists. What other causes or parts could be the problem?

March 21st, 2024

Sign Up to View Answers

Create an account to view answers and interact with the community!

Related Questions

I have a KitchenAid thermal-convection oven from 1998. The control panel lost its lights and displayed an error code E3, and now it only shows the time. I believe it's the electric clock control board, which is expensive. Should I attempt to repair it myself, or replace the entire stove/oven?

October 25th, 2023

My Sharp Carousel Convection Microwave 900w made a pop noise when starting and now nothing operates, including the display. Power is going to the power point. What could be the issue and what should I check?

March 16th, 2024

My Frigidaire free-standing range's oven and broiler will not heat, but the cook-top works fine, and the clock and other settings display correctly. What could be the issue, and is it more cost-effective to repair or replace the appliance?

September 29th, 2023

We have a built-in KitchenAid Microwave that is approximately four years old. Recently, we have experienced several instances where the Microwave has come on by itself. When noticed, if we opened the door it went off. However, if we then closed the door it came back on again. This is obviously a very hazardous situation. Have you ever heard of this problem with any microwave? Is there anything external to the microwave that could be causing this problem (possibly a cordless phone)? Is there anything we can do to preclude this problem short of turning off the breaker controlling the microwave or opening the door every time we leave?

October 24th, 2023

I have a Maytag refrigerator and regularly replace the water filter. I'm using the Maytag UKF8001, as we always have. I installed the replacement filter, and now the water trickles out. I tried reinstalling the old one, same thing. It just trickles. The water lines are clear and aren't frozen. Again, it worked one minute, I replaced the filter, and then it doesn't work. I've pressed the two "buttons" when the filter isn't installed and water does come out. The one on the top appears worn. What can I do?

February 27th, 2023