Courtney B. asked
I have an LG washer that was locked up with the basin full of water and flashing an error. I followed a video to remove the back of the drum to reset it, but found no sensor where the video indicated one should be. What is the issue with my washer, and how can I fix it?
April 20th, 2023
Jonathan G. answered
The issue with your LG washer is likely a clogged or failed drain pump, which is a common problem. H...
April 20th, 2023
Create an account to view answers and interact with the community!
I need to replace the filter in my KitchenAid refrigerator, but I can't figure out how to install it. The model number is KSSC42FTS15, and the ice maker isn't working. The filter box says it should go on the bottom, but I don't see where to put it. The fridge doesn't have a water spout or ice spout, and the filter doesn't look like the ones shown online. What should I do?
May 6th, 2024
I have a GE appliance (model PVD28BYNBFS) with intermittent water leaking from the dispenser area and icemaker failure. I have replaced the water solenoid at the dispenser controls, the icemaker, and the ice motor inside the evaporator. However, the issue persists with ice thawing and water dripping to the floor. What could be causing this and what should I check next?
January 9th, 2024
My Whirlpool stackable washer will not spin or drain. It happened about a month ago, and I tried a few more cycles with the same result. The washer is not making noises, it just won't drain or spin. I removed the washer from its casing but haven't done any further repairs. What could be the issue and what steps should I take to fix it?
February 10th, 2023
My freezer is at -2 degrees, but the icemaker is thawing and leaking water down the door. The ice room is around 40 degrees, and there was a chunk of ice stuck to the blower assembly. After replacing the blower assembly, the icemaker worked fine for a week, but now the ice is melting again, and water is dripping from the ice room. What could be causing this issue?
January 20th, 2024
When I set the oven for bake and enter the temperature, it briefly seems like it's going to start heating up, but then 'probe' appears on the display. If I hit clear, it flashes between bake and probe. My GE electric oven is about 15 years old and this issue has been going on for a few weeks. What could be causing this and what can I do to fix it?
November 16th, 2024