Jake H. asked
I have an older front load Maytag Neptune washer, coin operated. The clothes suddenly started to be left very wet when the cycle finished, and it never gets up to full speed. Just does a slow sing right to the end. I checked and do not see anything blocking the drain pump, and I also replaced the motor control board less than a year ago so I doubt it is either of those problems. What could be causing this issue and how can I fix it?
March 19th, 2024
Heather Z. answered
The issue is likely due to either the door latch not locking properly or an out of balance switch fa...
March 19th, 2024
Create an account to view answers and interact with the community!
I am having a problem with my front-loading washer. After re-connecting the pressure switch and hose and plugging in the washer, the same sound and flashing door lock light occur. What could be causing this and what other steps can I take to resolve it?
December 15th, 2024
The controls on my unit will no longer change the fan setting or raise the temperature setting. I cannot find the remote. What is the chance that the remote will allow me to change the fan setting and raise the temperature?
November 24th, 2024
I cleaned my Westinghouse Freestyle wall oven and now it is not heating, although the grill works. What could be the issue and what steps can be taken to fix it?
July 30th, 2024
I have a brand new Frigidaire French Door model FGHG2366PFA that is not cooling right out of the box. The compressor is running and I hear a gurgling sound, but there is no frost on the evaporator. The refrigerator was delivered on its back and stood upright for 24 hours before use. What could be the issue and how should I troubleshoot it?
July 25th, 2023
Hello, I have a Frigidaire Affinity washing machine model # Atfb7000epo that will not final spin. I have cleaned the coin trap and the drain pump appears to work properly. The tub drains out in about ten seconds. The door latch appears to work properly also, the door locks and the door lock light comes on. The drive belt is on. When it should be on the final spin all it does is hum loudly. Any suggestions?
December 6th, 2024
