Deborah B. asked

🔌  Appliance

I just bought a used Maytag Neptune model MAH 5500BWW and it isn't spinning out completely. The clothes are still wet after the cycle. I suspect something might be jarred or not level from moving it. What could be causing this issue and what can I check?

March 14th, 2023

John N. answered

The issue you're experiencing is likely due to a failed out of balance switch, which can happen if t...

March 14th, 2023

Sign Up to View Full Expert Answers

Create an account to view answers and interact with the community!

🔌Related Questions

I have a GE top loader washer model # XXXXX that flooded due to a failed sump. After drying and re-energizing, the washer fills and drains but won't spin or agitate. I've replaced the motor and control panel board, checked continuity on the lid switch, and tried resetting by opening/closing the lid. No error codes are showing, and I suspect the shaft/mode controller might be damaged. What else can I check or replace to resolve this issue?

June 27th, 2024

My Maytag dryer model #XXXXX 5500 AYW isn't starting. The thermal fuse, high limit on the element, thermistor next to the thermal fuse on the blower housing, and door latch are all functioning correctly. What could be the issue, and how can I troubleshoot it further?

July 7th, 2024

I have a Whirlpool dishwasher DU1055, 5 years old. It was working fine until this morning when the cancel light and the normal light started blinking. I tried unplugging and plugging it back in, but the normal light still blinks. The buttons don't respond, and there's no beep when pressed. The normal light blinks fast, and the control locked light is not lit. What could be the issue, and how can I fix it?

July 24th, 2023

The boiler (gas) on my ERD30 Dacor stove will not come on. What could be the issue and how can I fix it?

June 14th, 2024

How do I set delayed bake on my HD 1728 oven? When I select 'cooking mode', there is no 'delayed bake' option. Additionally, when setting the end time, the hours and minutes skip, making it difficult to set the desired time. Is this normal, and if not, what could be the issue?

August 9th, 2024