asked

I'm a contractor installing a new LG DLG6101W gas dryer. I just converted it to propane, and the flame is terrible, flashing 'Flow sensor,' indicating a possible blockage in the exhaust, which I've cleaned. The LP pressure at the manifold is 7", within specs, but the flame is blue with too much orange. The flame stays on for 20 seconds, then goes out three times, causing the dryer to blink 'Cool' and 'Flow sense' before turning off. What could be causing this issue, and what steps should I take to diagnose and fix it?

November 12th, 2023

Sign Up to View Answers

Create an account to view answers and interact with the community!

Related Questions

I replaced the control board on my GE GTW685BSL1WS washer and selected the wrong program. How do I get back to programming mode to select the correct model?

March 28th, 2024

My Bosch refrigerator (model B22cs50) is not cooling, even though it seems to be running and the lights are on. I have checked the temperature settings and performed a self-test, which showed no error code. What could be the issue, and what steps can I take to diagnose and potentially fix it?

February 8th, 2024

I have a Maytag Bravos XL MCT top load washer that is throwing the codes F2 E1. How much will it cost to fix, and if it's the control board, can I use one from a smaller version of the Maytag Bravos?

July 19th, 2023

My dishwasher was running on its own with the door partially open, and the timer showed .30. I tried to cancel it, but it didn't reset. The dishwasher is about 2 years old, model FGID2476SF7AAn, and serial number KH03124480. There was no water inside, but it sounded like it was trying to drain. I hear fast beeping sounds every few minutes, and the light showing minutes is still on, even though the machine isn't running now. What could be causing this issue?

August 30th, 2024

Is there a reset button on a GE Profile oven, and how can I troubleshoot an issue where the oven is not working but the clock is? The oven is gas and worked fine yesterday, but today it won't do anything. The only thing working is the clock, and I can't reset the time. The issue started after a power outage that lasted about an hour.

December 31st, 2023