Samuel W. asked
I've run my Sub-Zero freezer through all its service diagnosis modes and it checks out good, with no fails or troubles through the control board. I've manually put it into defrost cycle, and the sensor and heater work properly, but the unit continues to run even after these settings have been reached. I don't know when it's supposed to go into defrost—does it automatically go into defrost after the temperature is satisfied, or is it a time-based defrost?
April 16th, 2024
Christopher B. answered
The Kitchen Aid refrigerator you mentioned uses an electronic control board to initiate the defrost ...
April 16th, 2024
Create an account to view answers and interact with the community!
We replaced the belt and pulley on the bottom of our washer, but there is a small spring we don't know where it goes. The washer wasn't spinning or draining, and we found a broken belt underneath. What should we do with the small spring?
April 9th, 2023
My dryer top is still hot a day after doing laundry, even though we just replaced the bushing and belt a month ago. It doesn't seem to be getting hot enough while running, and I unplugged it last night fearing it may catch fire. What could be the issue and what should I do?
November 23rd, 2024
Whirlpool WFW9150WW00 Type 832-A Serial #HL01903268: The dispenser does not empty completely, causing liquid to leak out of the tray and down the outside of the machine, draining on the floor. The plastic dispenser tray has been removed, disassembled, and cleaned, and all ports are clear. What could be causing this issue and how can it be resolved?
October 20th, 2024
Kenmore Elite Trio model 596.77609801: Both digital displays for the freezer and refrigerator read 'Off'. Cooling is reduced, but I hear something running. How do I turn the cooling back on?
October 5th, 2024
The control panel above the glass top Maytag oven I have has a "burned out" round spot on top about the size of a quarter; getting bigger; It is black with a silver spot in the middle. Is it dangerous; do I need to replace the control panel... mainly, is it dangerous??
April 15th, 2023
