Briana M. asked
My Amana ARS9269BS/PARS9269BS0 refrigerator stopped cooling, with lights and fans still running. I've changed the temperature settings, unplugged and plugged it back in, and even turned it off for a few days, but it only worked for 3-4 days before stopping again. I've checked the resistance of the compressor windings, replaced the start device, and cleared the condenser coils, but the issue persists. I've heard clicking sounds when it's not working and noticed the compressor gets very warm. I'm considering bypassing the thermostat or defrost control board to isolate the problem or creating a compressor run box. What could be the issue, and what steps should I take next?
October 26th, 2024
Perry R. answered
The issue with your refrigerator is likely due to the Tecumseh compressor, which has a history of be...
October 26th, 2024
Create an account to view answers and interact with the community!
I have a GE Profile oven that is self-cleaning, but I lost the paperwork and do not know what buttons to push to start the self-cleaning cycle. How do I get the oven set to self-clean?
March 24th, 2023
We have a Wolf Cooktop Model CT36GS (LP), about 5 years old. Occasionally, there is a pop/explosion of gas from under a pot when a burner has been on for some time. The problem goes away for a few weeks after re-tightening the brass tube/7/8" nut holding down the burner assemblies, but then returns. Is there a gasket kit and Loctite fix available from Wolf, as some blogs indicate? How can I get the kit?
September 11th, 2024
My Frigidaire Affinity front load washer, model number FAFW4011LW0, is not entering a high-speed spin to drain water from the clothes, and the timer is malfunctioning. It shows 5 minutes remaining for 10 minutes and then turns off. What could be the issue and how can it be fixed?
January 29th, 2023
Hi Kelly, I can select any cycle and when I push the start button I can hear a 'Beep' but nothing happens. Any ideas?
October 4th, 2023
I get a rattle from the bottom of a Kenmore 80 Series washer at the end of the spin cycle. It lasts about 2 seconds. The rest of the cycles, water fill, and everything else run normally. What could be causing this rattle and what should I do?
March 13th, 2023
