asked
My Bosch dishwasher, model SHV68T3lCu/04, is giving error codes E24 and E23, and making a clunking sound from the pump. I have already cleaned all hoses and removed glass from the circulation pump. What could be causing these issues and what should I check next?
August 20th, 2023
My Kenmore series 80 dryer (model ###) ###-####, which vents directly outside, is not drying clothes despite having good airflow and heat. The internal venting has been cleaned, and the dryer looks relatively new (about 5 years old). What could be the issue, and how can I troubleshoot it?
January 6th, 2023
My Bosch refrigerator is showing 'IWD off' on the display panel and I am unable to turn it off to get ice and water. The issue started when I brushed against the panel, and I've tried holding each icon down for 5 or more seconds and turning the refrigerator off with the off/on switch for 5+ minutes. Is there any other way to get the 'IWD off' signal off so I can again get water/ice?
March 31st, 2024
We have a GE Model GSE25HGHBHWW side-by-side refrigerator-freezer. The ice maker is making a loud clicking noise. The noise has been intermittent for about a month, and we turned the ice maker off for several weeks, which seemed to stop the noise, but it has returned. What could be causing this noise, and what steps can I take to fix it?
January 1st, 2023
I have a Kenmore refrigerator model 790.71033.010, approximately 8-9 years old, where the freezer is cooling but the refrigerator section is warm. I unplugged it for a few days, replaced the defrost sensor and thermistor unit, and noticed that the freezer is working fine with cold air blowing into the ice maker in the refrigerator door. However, the refrigerator section has barely any air movement and is around 54 degrees. What could be causing this issue and what steps should I take to diagnose and potentially fix it?
January 21st, 2023
I have a GE Profile dual fuel range Model PC2S910SEF3SS with 'LOC' displayed and control locked out. When I press and hold the Range Lockout pad for three seconds, a first beep is heard when the pad is pressed and a second beep is heard after three seconds. However, instead of unlocking the controls, there is a low hum and the LOC flashes for about 30 seconds, then the hum stops and the display shows F6, accompanied by 3 beeps. I can then press the STOP pad to have LOC flash for 30 seconds again and stay on constant LOC. This cycle can be repeated, but the other control pads don't seem to work at any time. What could be causing this issue and how can it be resolved?
June 25th, 2023