Stanley S. asked

🔌  Appliance

My control light is stuck on and none of the other buttons will take it off. It stopped with a load of jeans in it. There is water still in the machine, so it did not spin out yet. Help. It's a Maytag 5 years old, front loader.

August 31st, 2024

Mary C. answered

Try holding down the cycle end signal for about 5 seconds to see if the control lock light goes out....

August 31st, 2024

Sign Up to View Full Expert Answers

Create an account to view answers and interact with the community!

🔌Related Questions

I have a Danby Beverage Fridge, model DBC039A1DBD, which is inoperative. The only functioning part is the blue digital temperature readouts, which are adjustable. There is no interior light, compressor operation, or fan operation. I have checked for 120VAC at the distribution block before the power goes to the thermostat, removed the door switch and used a jumper, and checked for voltage across the switch wires, which showed no voltage. The switch has good continuity in both normal and depressed positions. Should I return the fridge for a refund?

July 14th, 2023

I have a Jennair electric slide-in oven that is about 2 years old. The BAKE function won't turn on and the display keeps switching to the KEEP WARM function. What could be causing this issue and how can it be fixed?

August 31st, 2023

My Frigidaire front load washer model GSTF1670AS0 has been taking almost 3 hours to finish a load due to slow water filling. I've checked the inlet hoses and they are clean. What should I do next?

May 20th, 2024

Hello, I have a Kenmore model 587.15262900 and it has low water pressure. The water only makes it to the middle water spray arm but not the top. We removed the lower water spray arm and screen to check for clogs/obstructions. No change. We replaced the middle water spray arm because the seal was old, but the same problem. We then replaced the water pump assembly and still have no water pressure. What could be the problem?

April 25th, 2024

I have a Jenn Air gas range model #JDS8850AAB and it is showing error code F1-9. What does that mean and what is the least expensive way to repair it?

July 12th, 2024