William P. asked
My front-loading washer (GE Model GTW335ASN0WW) is not extracting water properly during the spin cycle. This has been going on for about three weeks. I have tried balancing and restarting the washer as per the troubleshooting directions, but the spin cycle starts normally and then slows down shortly after. The clothes are still too wet, and after the Drain & Spin cycle, the water turns back on and the Fill cycle starts over again. What could be the issue and what steps can I take to resolve it?
August 25th, 2023
Debra C. answered
The issue with your washer not extracting water properly during the spin cycle could be due to exces...
August 25th, 2023
Create an account to view answers and interact with the community!
The freezer door seal on my Liebherr CS 1311 Index 14d/237 refrigerator is split and causing ice buildup. How can I replace the seal, and is it something I can do myself?
January 6th, 2024
I have a less than 1-year-old heat pump dryer that beeps twice when the power button is pressed, but does not function. The door is closed completely, the water tank and filters are empty. I have toggled the breakers, emptied the water collection tank, cleaned the lower filter, and performed a hard reset by turning off the breaker for 5 minutes. The dryer still beeps twice and does not start. What could be the issue and what else can I check or do?
December 19th, 2023
I am receiving error messages (E13 and E27) and can't open the door to my Bosch washing machine. I was doing a load of laundry when the issue started. I have checked the drainage tube, let out some water from the valve, and tried the drain and spin cycle. What else can I try to resolve this issue?
October 15th, 2023
I have a Samsung Steam front load washer, model WF45R6100AC, that is 2 years old. It lights up normally but no water comes through. What could be the issue and what steps can I take to fix it?
June 5th, 2023
We have an older model DU1145XTPBA, sn FV2115994. I cannot get the machine to start a cycle. I can toggle the 2-4-6 delay LEDs, or the light or Rinse LEDs, but cannot start a cycle. I have checked power, replaced the control board including a change of the thermal fuse, but cannot get a wash cycle to commence. Is there a closure interlock or some other process that I am overlooking?
July 17th, 2023
