Brooke J. asked

๐Ÿ”Œ ย Appliance

My GE Profile countertop ice maker has stopped making ice. I've tried running a cleaning cycle and draining the tube, but it didn't help. The ice maker is about 6 months old and I haven't replaced the water filter yet. Where is the water filter located, and how do I get a replacement? Additionally, what else could be causing the issue and how can I troubleshoot it further?

November 28th, 2024

John G. answered

The issue with your GE Profile countertop ice maker not producing ice could be due to several factor...

November 28th, 2024

Sign Up to View Full Expert Answers

Create an account to view answers and interact with the community!

๐Ÿ”ŒRelated Questions

Accidentally touched the locked button on my stove, and now I canโ€™t use it. The stove is electric and was installed in 2012. What can I do to unlock it?

February 29th, 2024

We have a 5-year-old GE dishwasher with a model number GDT69522J0SS. The door is closing but the dishwasher thinks the door is not latched, preventing it from running. The door was always difficult to close but always latched before. Today, it didn't latch at first but is now latched but not recognized as latched. What can be done to fix this issue, and what would be the estimated cost if a professional repair is needed?

March 21st, 2024

The ice maker in our recently purchased refrigerator (model wrqa59cnkz) stopped working after a storm disrupted the water pressure pump, which has since resumed functioning. Despite turning the ice maker off and on and pushing the reset button, the ice maker still doesn't produce ice, and the pump only hums occasionally. What could be the issue, and what steps can be taken to resolve it?

October 23rd, 2024

My Whirlpool Duet front load washer from 2016 is flashing error codes F03 and E01 and won't unlock. I've cleaned the drain trap and hoses and tried unplugging it. What could be the issue and what should I do next?

September 22nd, 2024

My top-loading washer isn't working properly. During the spin cycle, it acts like it's off balance and doesn't spin out. The agitator also seems to be sitting higher than usual. I've tried balancing the load but the issue persists. What could be causing this and what should I do?

January 27th, 2024