Anthony A. asked
My Kenmore dishwasher model # 665.13833K600, which is about 12-13 years old, fills with water, starts to run normally, but at the end of the cycle, the dishes are dirty. I've checked the fill valve, float switch, and replaced the pump assembly and chopper. The old motor ran fine when powered up. The dishwasher sometimes not cleaning, then fine, then not cleaning. It fills and starts to run normally, then after a few minutes it quiets down. When I open the door, no visible water inside, but can hear the pump running. The drain hose has a high loop under the sink, and the check valve in the drain hose at the pump appears to function as it should. What could be the issue and what should I check next?
October 27th, 2024
Todd S. answered
The issue is likely due to a faulty control board, which is causing the dispenser to open at the wro...
October 27th, 2024
Create an account to view answers and interact with the community!
My Jenn-Air gas stove, which is 11 years old, is not getting hot or warming up at all. One burner does not ignite and needs to be lit manually. The broiler is working, but the bake function is not. We tried resetting the stove and replaced the broil igniter, but the bake function still doesn't work. How can we get the oven to work?
February 15th, 2023
I just bought a brand new gas stove and converted it to LP. The burners work fine, but I'm not sure if the oven regulator switch is pointed in the right direction because it's hard to see. What position should the lever be in for the gas to flow into the oven?
April 30th, 2024
Hi, I have a stack unit washer that works fine but seems to use a lot of water, and the dryer just stopped working. I'm thinking maybe the switch. What could be the issue with the dryer, and what should I check?
July 12th, 2024
I have a WFW9200SQ00 front-loading washer that is not turning on, and no lights are coming on. I checked the power line filter and it has power to the CCU. What could be the issue, and how can I test it?
July 11th, 2024
I just bought a used Maytag Bravo Series 300 washer that won't finish the cycle. It drains but won't extract and spin, and it reloads for the next cycle. I've tried the reset sequence with the door, but it doesn't work. What could be the issue, and how can I fix it?
February 26th, 2023
