Alexis P. asked

🔌  Appliance

My LG Fuzzy Logic Top loader washing machine gives an error code PE. I have replaced the pressure level switch, but the error code PE still appears. What should I do?

October 13th, 2023

Diane H. answered

After replacing the pressure level switch and still encountering the error code PE, the next step is...

October 13th, 2023

Sign Up to View Full Expert Answers

Create an account to view answers and interact with the community!

🔌Related Questions

My Maytag 4000 series washer has a blinking red light by 'door locked' and won't power off, cancel, or run a cycle. The door is locked shut. What should I do?

March 23rd, 2023

I have a 20-year-old washing machine (Miele W1918) that occasionally has issues with not spinning completely, which is resolved by running the spin cycle again. Last night, it stopped during a wash cycle, and now there are no lights, and I can't access my clothes. What could be the issue, and what should I check?

August 10th, 2024

I am trying to replace the old control module of a Kenmore Built-In Gas Oven with a new one, but the instructions for the new module do not match the existing oven wiring. Specifically, the new module requires a purple wire to be attached to a relay switch, which does not exist in the oven's wiring. I have a yellow and a blue wire that are not attached to any terminals yet. How should I proceed with connecting these wires to the new control module?

July 12th, 2023

My GE top load washer (Model: WPGT9350) registers a 'laundry out of balance' error after spinning for 2-3 minutes regardless of the load size - even when empty. The washer is level, and the tub does not look or sound out of balance when this happens. The washer tries to re-balance 3 times unsuccessfully, leaving the clothes always too wet. What could be causing this issue and how can it be resolved?

December 18th, 2023

My front-load washer won't go into high-speed spin. Instead, it goes slowly one direction, then slowly the other a couple of times each way. What could be the issue and how can I fix it?

October 3rd, 2023