asked
My washing machine went through a normal cycle of washing and rinsing with fabric softener added, but it quit during the rinse cycle. The door light went out, and the green light returned to the wash cycle. When I tried to restart it, the door locked but it didn't do anything. I removed the clothes, drained the water, and checked the troubleshooting book, but couldn't find anything. After checking for loose contacts, restarting the machine, and it quitting again during the wash cycle, I need help diagnosing the issue.
February 19th, 2024
Where can I obtain a user manual for a phone Model # ***** GE1-A?
November 12th, 2024
My GE 240v Advantium oven, Model SCA2001FSS 02, Serial No HG900210K, manufactured May 2004, has had door switch problems for many years. I have replaced the switch many times, but now the red wire lead is charred and not making contact with the switch. It has slowly charred through the years, so I presume the solder from the wire to the connector was not great and the heat slowly burned the wire. Can I get the plastic connector replaced so the switch makes good contact? If not, can I bypass the switch by wire nutting the 3 wires together?
February 10th, 2023
We have an 8-10 year old Jenn-Air dual fuel oven/stove with a gas cooktop and electric oven. Recently, the control panel stopped working and displayed F1 and F3 error codes. After replacing the control panel and sensor, the new panel and surrounding metal became excessively hot, creating a fire risk. The oven works fine otherwise. The technician suspects a bad door gasket, but the issue started only after the panel replacement. What could be causing the excessive heat, and what should we do?
June 9th, 2024
I have a Marvel 3SWCE under counter wine cooler that stopped cooling. When plugged in, no fan, no compressor starts, and the control panel shows 74°F. The onboard diagnostics indicated that the mullion heater might be on or shorted, but I can't find it. Is there a mullion heater, and what could be the issue? Any help is appreciated.
September 14th, 2023
I have a front load Electrolux dryer that is flashing an E64 error code. It starts, runs for a little while, then stops and flashes the code. The dryer is heating, and even in air dry mode, it gives the same E64 error code. The blower is working fine, and the heating element is heating. What could be causing this issue?
September 8th, 2023