asked
My Whirlpool Cabrio washer (WTW6200SW0) makes a dull 'thunk' noise during the initial wash and more prominently between the wash and final rinse cycle. I have replaced the agitator dogs and the basket suspension. The washer works fine until it reaches the final spin (at the 13-minute mark on the readout), where it stops and makes the periodic thunk noise. If I manually change it to rinse/spin, it finishes the load without issue. What could be causing this noise, and what should I check?
January 31st, 2024
I have a GE gas stove, model PGB910SEM1SS, which is about 6 years old. The medium and extra-large burners do not ignite by themselves, but they start and burn evenly when I use a lighter. What should I do?
February 16th, 2024
Our Maytag top loading washer fills and runs until the final 9 minutes on any cycle, then it gives the LF error message. The water flow isn't the issue, it only gives the LF message at the 9 minutes mark, it fills fine to wash the clothes, but doesn't finish the cycle. We've taken to hose off and cleaned the filters. It is still doing it. What else can we try?
December 11th, 2024
My KitchenAid model YKESA907 (2004, 30 inch electric range) experienced a breaker trip during the self-clean cycle. After resetting, the doors are locked and the stove is unresponsive. I have switched power on and off, but there is no response. What could be the issue and what steps should I take to troubleshoot and potentially fix it?
September 29th, 2024
I have a Jenn-Air French door fridge that has stopped working. The power source in the wall is functioning properly. What might be causing this issue and what can I try to fix it?
September 11th, 2023
My new front load washer, a Whirlpool Model WFW75HEFW0, is showing 'h1' on the display every time I do a load. What does that mean?
May 15th, 2023