My Whirlpool Duet washer is displaying E01 and F09 error codes. I have replaced the pump motor and CCU board, checked hoses and drains for clogs, and found 16 ohms of resistance on the DP2 pins. The error codes appeared before and after the replacements. What could be causing these errors and what additional troubleshooting steps should I take?
February 7th, 2023
I bought a Whirlpool washer and it won't get beyond the sensing/fill stage. It won't fill with water, and I've followed the instructions exactly. What am I doing wrong?
March 10th, 2023
My Maytag washer is displaying error codes F5 and E3, and the door is locked and won't open. What could be causing this issue and what steps can I take to resolve it?
September 29th, 2024
My Maytag MVW7230HC washer's lid won't unlock. What can I do to troubleshoot and fix this issue?
November 18th, 2023
We just replaced the board as we talked about. The appliance spins once and then stops. We have already replaced the hall sensor twice, and we tried to measure it with a voltmeter but couldn't due to the small thin pins. We also replaced the stator. What could be the issue and how do we replace the main PCB board?
June 26th, 2023
I recently replaced the impeller motor on my Samsung dishwasher (model DW80R5060UG/AA). It runs a rinse cycle successfully, but any other cycle starts and then switches to a rinse cycle. What could be causing this issue and what should I check?
November 21st, 2023