Courtney S. asked

🔌  Appliance

The door lock assembly has been replaced. I tried to run the rinse and spin cycle, but the water entered the washer and then it stopped with the start/pause button flashing. The washer door unlocked about 1 minute after. What could be the issue and what steps can I take to resolve it?

October 24th, 2023

Janice S. answered

The issue could be with the Electronic Control Board, which may need a reboot. Here are the steps to...

October 24th, 2023

Sign Up to View Full Expert Answers

Create an account to view answers and interact with the community!

Sign Up with Email

🔌Related Questions

My LG dishwasher model number MEZ64589015 is stuck in a rinse cycle and does not progress to any other stage. I have tried different cycles, powering it on and off, and cleaning the filter, but the issue persists. What could be causing this problem and what steps should I take to resolve it?

March 7th, 2023

I have a Frigidaire Crown Series washing machine that is not spinning out the water from the clothes. It just started this issue last night and continued today. I tried unplugging it, but the problem persists. What could be causing this issue and what steps can I take to fix it?

November 30th, 2024

We have an LG inverter direct drive washer that is showing the code CL in the display window, which indicates the child lock function. We cannot figure out how to enable this function. What happened just before the code appeared was that we were starting a load and pressed the power button, causing all cycle functions to light up. This issue just occurred, and we have tried pressing all buttons and unplugging the washer. Is there anything else we should know or try?

March 3rd, 2023

My dryer stopped working and displayed an F3E2 error code. I had placed damp towels in the dryer, which worked fine for a couple of minutes before stopping with the error. This has never happened before. What could be the issue and how can it be resolved?

May 29th, 2023

My older Dacor wall oven, which I believe is gas and is about 15 years old, stopped working properly last night. When I tried to use the self-clean function, it started beeping loudly with an F8 error code that wouldn't stop until I held the cancel button for 30 seconds. After that, the 'OFF' light came on, and the oven no longer responds to any modes or temperature settings. The clock and light functions still work. What could be the issue, and how can I fix it?

June 19th, 2024