Deborah O. asked
The door on my Maytag Neptune washer won't always unlock. I have tried unplugging it for two minutes and that worked once, but more often than not the door won't release at the end of the cycle. Do I need a service tech?
June 26th, 2024
Rhonda M. answered
The issue is likely due to a faulty door latch assembly, specifically the wax motor. Here are the st...
June 26th, 2024
Create an account to view answers and interact with the community!
I have a 30-year-old General Electric double oven model KP36 002. The timer went out, and I replaced it with a cross-over electronic/digital timer. After reconnecting the wires according to the numbers on the old and new timers, the timer still doesn't work. I have 2 reds on #1, 2 whites on #4, and one orange on #2. I also have 120v coming into the timer on the red on #1. What could be the issue?
June 11th, 2023
I have a model SMH6140BB microwave oven that no longer heats food. It sounds like it's working and has 120VAC at the input to the high voltage transformer, and I can hear a 60 Hz hum. I replaced the magnetron, but it still doesn't heat. What could be the issue, and how can I test the power diode and high voltage capacitor?
December 23rd, 2024
I have a Sears Kenmore Oasis 110 27032603 with a fault code F50. I've already cleaned the speed sensor connections, but the issue has returned after 6 months. Should I replace the speed sensor, and if so, what is the part number and cost?
December 14th, 2024
I am looking for a wiring diagram for a Hobart A200T mixer with serial number XXXXX and model number XXXXX.
October 31st, 2024
I have a Whirlpool Dryer that starts running fine but stops blowing hot air during its cycle, only blowing cold air. I was told it sounds like the gas valve coils are bad. My model has a 2-prong and a 3-prong coil, but I see three parts with prongs: one with 4 prongs and two with 2 prongs. How can I identify and replace the correct coils to fix this issue?
July 9th, 2023