asked
The evaporator in the roof was completely frozen. I did the defrost drain kit, but it worked fine for a few days and then completely froze again. I replaced the temperature sensor on the freezer wall, but I did not see any temperature on the evaporator or any defrost bimetal. What else can cause this? The fan runs 24/7, and I’m not sure if the compressor is running. I also have an issue with a washer where the agitator in the middle when the unit is in full spin, I can grab the agitator and hold it still. The unit works fine but agitates super slow. Additionally, the fridge above that I started this thread with, I replaced that ambient temp sensor. Now when I went back the evap was 100% frozen again. I had them defrost completely for 12 hours and then try it again. It’s been 48 hours, and the freezer won’t drop under 24 degrees. Has to be some sort of evap leak or something at this point no? Shouldn’t freeze up within 24 hours?
December 8th, 2023
I have an LG dehumidifier (model LHD65EBLY7) that stopped working after being unplugged and turned back on. No lights come on when I try to start it, and I've tried different outlets and resetting the recovery pan. Is it repairable, and what steps should I take to diagnose and potentially fix the issue?
March 25th, 2023
Why does my Thermador oven say 'still hot' after a whole day, and it won't heat up when I try to use it?
January 10th, 2023
My Whirlpool washer is leaking on the heated fan dry option. Is the leak coming from the washer itself or from the area around it? Have you noticed any error codes or unusual sounds during the cycle?
August 10th, 2024
I want to self-clean a Titan oven that is more than 10 years old. When I turn the oven to Self Clean, do I also turn the temperature up to 300? I have mislaid the manual.
December 15th, 2023
My Whirlpool washer starts a cycle but doesn't finish and flashes 'sense' then 'done' with the locking lid. The lid is locked during the cycle, but it won’t spin at the end. There are no noticeable error codes or flashing lights on the control panel. What could be the issue?
July 29th, 2023