asked
We have an 'F3' code and then it beeps. When we unplug it, we get a 'PF' code. We looked in the book but couldn't find what these codes mean. The appliance is a GE JES1034WF001, and we live in an older condo unit in Florida where we seem to be experiencing power surges with our lights.
February 12th, 2024
Can you provide step-by-step instructions for replacing Bosch part #962460, the washer door gasket?
June 26th, 2024
I have a GE Profile Harmony dryer that is not producing heat or blowing air. The unit runs fine otherwise, with clothes tumbling and everything else operating normally. I have tried resetting the unit by turning it off and unplugging it, which temporarily resolved the issue but it has since stopped working again. What could be causing this issue and what can I check?
March 5th, 2024
My Asko dishwasher Model 3250 initiates a wash cycle, but the pump runs for about two minutes before the dishwasher shuts off. The 'Pots and Pans' and 'Heavy Wash' icons on the control panel blink simultaneously. This happened once before, and an Asko repairman reprogrammed the control panel to bypass a flow meter and actuate a flow timer for $90. Can this be the same problem, and if so, can you provide panel codes so I don't have to call the repairman back (120-mile round trip)?
January 7th, 2024
I have a Kenmore ceramic top stove with an oven that only has a top element and no visible bottom element. Is this normal, and is a bottom element needed for proper oven function?
July 22nd, 2024
What should be the resistance on the thermostat with a meter for a Kenmore 911.45565893 model, and what is the resistance reading I have, which is 1.08 ohms?
May 31st, 2024