asked
We have replaced the part that regulates water to the ice maker and cold water line. Our ice maker had quit making ice, but now we have water to the ice maker, but also have water messing up the ice and ice bucket. What is wrong?
January 8th, 2024
My Maytag Washer 3000 stopped mid-cycle, has power but no error code, and the controls are locked with the 'Add Clothes' and 'Controls locked' indicators lit. The doors are also locked. What could be the issue and how can I resolve it?
January 24th, 2024
I have a Samsung refrigerator model RF260. I need to change out the water filter. Do I have to turn off the water to the fridge? The red light is on, and it’s not making ice. The filter is very tight, and I want to use vice grips to get a good handle to twist.
April 8th, 2023
My Whirlpool Gold Side-by-side refrigerator (Model GSS30C6EYYOO, manufactured 07-11) has stopped making ice and the freezer compartment is less cold, causing ice cream to slightly melt. The replace water filter light is not on, and the filter was recently replaced. I have inspected the water line for kinks, cleaned the rubber seal on the freezer door, ensured the door is tightly shut, rebooted the fridge, adjusted the freezer temperature, cleaned and inspected the ice bin, and turned the ice making switch off and on again. My wife heard a slight 'buzzing' noise coming from the fridge. What could be the issue and what should I do?
March 8th, 2023
I have a KitchenAid model KUDD01DPPA 1 double drawer dishwasher (1987? S/N FPU3708715) with a non-standard size plastic fill hose that needs replacement. The hot water shut off valve was leaking, so my plumber replaced it but cut the fill line, making it difficult to fit a standard size hose. How do I replace the non-standard size hose, and is it complicated to remove the drawers to access the hose inside the unit?
November 12th, 2024
I am an electrician and some wires came out of a connector from a control panel for a Kenmore Elite range. The bracket that holds the panel with double-faced adhesive tape came loose, causing some wires to come off an edge connector. The edge connector has 8 positions, with the #1 wire (brown) and #6 wire (orange) still on. The yellow and red wires came off. Can you tell me where to insert the (position) for the red and yellow wires?
March 12th, 2024