Danielle N. asked

🔌  Appliance

How can I get my top loading Whirlpool washer to finish its cycle? The washer has been stuck all day, and I have tried resetting the cycle to drain and spin, but it remains locked. Where can I find the model number, and what steps should I take to troubleshoot and potentially fix the issue?

December 20th, 2024

Denise G. answered

To troubleshoot your top loading Whirlpool washer that is not finishing its cycle, follow these step...

December 20th, 2024

Sign Up to View Full Expert Answers

Create an account to view answers and interact with the community!

🔌Related Questions

The alarm on my Sub-Zero refrigerator (model BI-42 or 48SD) is going off, and the ice dispenser is not working. Everything else seems normal, and I want to turn off the alarm without turning off the power to the refrigerator. How can I reset the alarm?

March 30th, 2023

My GE dishwasher, model gdf510psj0ss, is 6 years old and has 3 lights flashing (clean, start, and heavy) with no error codes displayed. I have tried turning the power off for a few hours and holding the start and cycle buttons to clear any potential error, but the issue persists. What could be causing this and how can I fix it?

January 28th, 2024

My Whirlpool fridge/freezer model WRX988SIBM03 won't cool below 42°F for the fridge and 22°F for the freezer. A repairman diagnosed a refrigerant leak and suggested replacing the upper dryer and refrigerant. What should this cost and does it sound like the right fix?

January 14th, 2023

I just purchased a new Samsung RF29A9771SS refrigerator that keeps popping the GFCI outlet. The outlet tests and resets correctly, and the refrigerator has been doing this for 5 days, popping 2 to 3 times a day. The house was built in 1970 with aluminum wiring, and the circuit feeds 4 GFCI outlets in the kitchen. What could be causing this issue and what should I do to resolve it?

October 29th, 2024

I have a Bosch wall oven (model HBLP451RUC/03) that is 4 years old and electric. The display shows an E010 error code. I have proper voltage to the unit and tested for continuity in the harness to the user control board, getting 12VDC. I cannot put the unit into diagnostics mode. What could be causing this issue and what should I check or replace?

January 17th, 2023