asked

How do I adjust the lower (refrigerator) door on a RB15LN-OA to fix the issue of the magnetic seal being too compressed at the top and having a gap at the outboard edge? Specifically, do I need to remove the plastic 'dust caps' near the hinge pin and use an Allen wrench to loosen the hinge mount?

January 31st, 2024

Sign Up to View Answers

Create an account to view answers and interact with the community!

Related Questions

My Kenmore Gas Ultrabake oven, model number 66572002104, no longer ignites the burners or oven. I can manually start the burners with a lighter, but there is no gas hissing or clicking ignition sounds from the oven. The display and timer functions are working, and the burners release gas but do not ignite. Could moisture from boiling water on the back burner be a problem?

November 2nd, 2024

I have a smaller size chest freezer. There was a power outage and the food inside spoiled and went unnoticed for quite a while. After a lot of hard work I got the smell out of the main part of the freezer, but it remains inside the freezer lid. What can I do?

September 29th, 2024

My Jenn-Air JGS8860BPD touch panel is malfunctioning. Only the 1, 2, 3, 4, 5, 6, and 0 keys make a beep sound when pressed, while all other buttons do not work. Additionally, the 'setup' button stopped working several months ago, and now all other buttons are out as well. Is this a problem with the touch panel itself or the electronic circuit board?

April 4th, 2024

Samsung refrigerator model RF266ABRS/XAA had a power failure, now the compressor and fans are running but the display shows 88's on both sides. The refrigerator display alternates between 88 and 86. Can't reset. Is the main control panel bad?

April 24th, 2023

I have a Bosch dishwasher (serial number SHE43M02UC/53) that runs down to '1' and then keeps running without draining, and it doesn't generate heat. I believe I need to replace the control module. Before ordering the control module (which costs over $100), I want to be confident that I've correctly identified the problem and ordered the right part. Additionally, can a DIYer replace the control module?

May 1st, 2024