asked

I cannot find the procedure to reset the motor on an older Whirlpool washer, model # GST9679PW3. I had to repair the arm that triggers the lid sensor, and after that, the washer started a spin cycle but was out of balance, which I presume tripped the motor codes. It refilled after the spin cycle but then stopped. All online procedures I found are for newer models, so I am not sure if they work for my specific model.

July 14th, 2023

Sign Up to View Answers

Create an account to view answers and interact with the community!

Related Questions

We have a new model LWC3063BD microwave that is not heating. It is part of a microwave, oven combo. The issue just started, and we had an earlier problem with the turntable not rotating, which was fixed. What could be causing the microwave not to heat, and what should we do?

January 24th, 2024

I need a replacement part for my Beko refrigerator, model # G91629NWU. The flap along the left side door is broken and does not allow the door to close all the way unless manually flipped back into place. The flap cracked a few months ago, and last week, the little knob at the top that slides into a piece attached at the top of the main part of the fridge broke off. What replacement part do I need, and can I send a picture for verification?

June 14th, 2024

I have a Sub-Zero refrigerator model 650 or 660 with a bottom freezer drawer. I removed the top basket due to broken wheels causing the drawer to jam and not close properly. Now, the freezer is not working. Is there a switch or mechanism that the drawer might have triggered to make the freezer work, and how can I troubleshoot this issue?

April 13th, 2023

Our refrigerator is too cold, freezing our food and affecting the water line for water and ice. It is set to the warmest option between cold and coldest. We just discovered this issue after being away for two months and don't know what to try. What could be causing this and how can we fix it?

March 21st, 2023

The rubber piece at the door of my front load washer is full of gunk. I have tried over-the-counter washer cleaners and am currently running a hot water cycle with bleach only. What should I do to clean or replace the gasket?

July 17th, 2024