Destiny C. asked
I have a 7-year-old GE side-by-side refrigerator (model GSH5KGXCCSS) where the water and ice dispensers do not work when the levers are pressed. The control panel shows 'O' and then the temperature when buttons are pressed. I have tested the ice cube discharge solenoid, door microswitch, water dispensing microswitch, and water solenoids, all of which are functioning. How can I diagnose and fix the issue with the control panel and motherboard?
September 4th, 2024
Robert C. answered
The issue you're experiencing is likely due to a faulty main control board, which is a common proble...
September 4th, 2024
Create an account to view answers and interact with the community!
My Maytag Heavy Duty Top Loader (model A882) is making a buzzing noise and not filling with water after being reconnected. What could be the issue and how can it be fixed?
April 8th, 2024
My GE microwave model PVM2070DM1BB, built in 2007, has a touch screen that lights up but the buttons don't work after a power outage. The vent and lights are functioning. Is the issue likely due to a fuse, and if not, what could be the problem?
December 14th, 2023
My KitchenAid ice maker (model #KSRA25ILSS13) is not working. I've replaced the ice maker, water valve, filter, and ensured the line is clear. I've also unplugged the fridge to reset it and turned it off with the switch. The water pressure is good, and the water dispenser works fine. However, there is a red light blinking on the ice maker switch. What could be the issue and how can I fix it?
April 30th, 2023
How do I remove the bottom drawer of a Fisher & Paykel dishwasher in order to remove the whole unit from the cabinet? The dishwasher is a curved front two drawer model, about ten to thirteen years old, and I need to remove it as I am removing the cabinets. I originally installed it but have forgotten how to remove the drawer in order to access the two screws anchoring it in the cabinet.
May 1st, 2023
I have a Sears Kenmore front load washer model number 417.48102701 with a serial number XC84407339. The problem is that clothes are coming out dripping wet because the washer will not go into full spin at the end of the wash cycle. The drain pump is working fine, and I have replaced the front control panel, but it still won't go into a fast spin at the end. The drum motor works well during the wash cycle but won't go into the fast spin at the end to remove water from the clothes. What could be the issue?
September 14th, 2024