Jamie M. asked
I have a Dacor SGM466 and the ignitors stopped working, the electrical and circuit breakers are fine. Is it one ignitor that has gone out, or an issue with the modulator, how can you tell?
October 8th, 2024
Cynthia M. answered
If none of the burner ignitors are working at all, it is likely that the spark module has gone bad. ...
October 8th, 2024
Create an account to view answers and interact with the community!
I have a Kenmore Dishwasher, type 575-D, stock # XXXXX Model 665.16034402. We want to replace it with a similar unit. Where can I get the height dimension of this unit? IE, 23 7/7, 23 3/4, etc? Additionally, if the height from floor to bottom of the counter is only 33 5/8, can I install a new dishwasher with a standard height of 33 7/8 in the same location?
February 18th, 2023
I purchased a new Whirlpool, 29 cu ft, french door, water/ice in the door, freezer on the bottom refrigerator. After a couple of days, I noticed ice building up on the back, upper right section of the fridge compartment. The technician said this was an inherent problem and repaired it, but it happened again. I returned the fridge and purchased a new KitchenAid with the same features, but the same issue occurred. Have you heard of this problem and can it be permanently fixed?
January 13th, 2024
I have a Whirlpool Washer/Dryer model LTE 6234 AW1 and need to replace the motor part #279811 and belt #661570. How do I access the motor to remove the old one and install the new one?
September 3rd, 2024
My Kenmore Elite gas stove died while the cleaning cycle was operating. The display is dead and the door is locked. The stove top clicks, ignites, and burns just fine. Is the display burned out? Can I somehow unlock the door manually?
November 12th, 2024
How do I remove the rotor from a Fisher & Paykel GWL11 to change the RPS sensor?
December 2nd, 2023
