asked

I have a front loader washer and dryer. The installers left paper all over the front, and my daughter used Goo Gone to clean it, resulting in a cloudy residue on the front of the dryer. What can I do to remove this residue?

August 18th, 2024

Sign Up to View Answers

Create an account to view answers and interact with the community!

Related Questions

My Amana side-by-side model #DRS2362A freezer is not freezing. The coil inside is not frosted. What part could be broken to cause this?

November 14th, 2023

I have a Jenn Aire side-by-side refrigerator. The freezer side is too cold, but the fridge temperature is too warm. I noticed ice buildup in the freezer two weeks ago, so I defrosted it. Now, the fridge temperature has risen to 48°F. The fridge is set slightly above the middle level, and the freezer is set slightly below. There is also a switch inside the fridge that toggles between 'cool' and 'cold,' which is currently set to 'cold'. What could be causing this issue?

November 16th, 2024

I am planning to purchase a Whirlpool Washing Machine WTW5700X(W) and will have the plumbing re-done since it will be relocated upstairs. I want to know if the washing machine draws any current once the wash cycle has completed, as I plan to install a Watts Intelliflow A2C-M Automatic Shutoff Valve that senses current to control water flow.

June 12th, 2024

I have a Whirlpool Heavy Duty Super Capacity Plus 7-speed 2-cycle washer, model #LSR7233DQ1 and serial #XXXXX. It runs through the cycle fine until it's time to rinse or drain the water, and it doesn't drain. Could this be due to a faulty motor, motor gasket, or bad wiring? I don't have the budget to replace the washer, but I am mechanically inclined and wondering if I can replace the motor or gasket to save the washer.

September 27th, 2023

I have a Kitchen Aid KS CS25INBL00 side-by-side refrigerator where the two bulbs at the top burned out. I replaced them with 40W 120V bulbs, but they won't light up. The bulbs at the back of the cabinet (down by the meat keeper) light up just fine and turn on and off with the door switch, just like they're supposed to. The control panel is functioning perfectly. Do I need new sockets for the bulbs at the top? The plastic does look a little burnt. Or is there something more expensive going on here?

June 12th, 2024