Savannah H. asked
I have a GE front load washing machine model # * serial FL200626T. When I try to start the machine, the start pause button keeps blinking and beeps twice. Not sure what's going on.
November 28th, 2023
Carrie H. answered
The issue is likely due to a failed door lock. Here are the steps to diagnose and fix the problem: 1...
November 28th, 2023
Create an account to view answers and interact with the community!
How to reprogram control board 12920710 on Amana AFI2538AEQ?
March 31st, 2023
I have a Maytag Bravos top load washer from 2009. It leaks during the pump cycle, and water runs out from underneath the front of the machine. I suspect a pump or related hose problem. How do I open the machine to access the pump if that is the issue? Additionally, there is a buzzing noise during the cycle, similar to a solenoid. What do you suggest?
October 27th, 2024
Clothes Washer - Maytag MAV4057AWW: Wobbles badly when spinning after rinse. Is it the Snubber Ring?
February 21st, 2023
I have a Hotpoint gas dryer model NVLR333GE0CC. Yesterday, it stopped working in the middle of drying. When I press the start button, it hums normally but stops when I let go. If I manually press down the door sensor and press the start button, it hums but doesn't tumble or heat. What do you think the most likely problem is, and considering the dryer is 10 years old, should I get it repaired or buy a new one?
August 10th, 2023
My dishwasher flashes ER, sensing, sanitized, drying, and low. The only function that works is the 94-minute cycle. To erase the flashing codes, I run my finger across the top board, and it stops for a few seconds. What is causing this issue and how can it be fixed?
May 15th, 2023
