Jessica D. asked
I have a GE model GHWN4250D1WW washing machine. All cycle lights are flashing, one second on, one second off, which started after a power outage during a wash cycle. I've tried unplugging the machine and resetting the circuit breaker, but the issue persists. The user manual doesn't address this problem. What could be the issue and how can I fix it?
September 9th, 2023
James L. answered
The flashing cycle lights on your GE washing machine are likely due to a damaged control board cause...
September 9th, 2023
Create an account to view answers and interact with the community!
The ice maker in my Samsung RS261MDWP refrigerator (about 3 years old) is not making any ice, but water is dispensing out of the front. Do I need to access the back of the refrigerator to fix this issue, and if so, what steps should I take?
October 1st, 2024
I am trying to replace the electrical cord on my Kenmore canister vacuum model 116.29319210. I have removed two screws, but I cannot locate the other two screws or figure out how to remove the cord rewind button to access the electrical cord. How can I proceed with this repair?
November 23rd, 2023
My Whirlpool dishwasher, model W10431031A, was set for a 4-hour delay several hours ago, and now it won't work. What can I do to resolve this issue?
May 5th, 2024
I'm working on a KitchenAid built-in refrigerator model number ksss42qjb00. The problem is no ice when the ice lever is pushed. I notice that the flapper door does not open all the way and closes too fast. As I press down on the ice lever and reach in with two fingers to open the flapper door all the way at the same time, the ice dispenses just fine. What parts do I order and what is the procedure to remove this dispenser to replace parts?
May 31st, 2024
I have a commercial whirlpool washing machine (model cam2742tq3) that only fills with 5 inches of water during the rinse cycle, which is less than the recommended 7-9 inches. I replaced the timer and the low water level switch, but the issue persists. What could be causing this and how can I resolve it?
February 3rd, 2024
