Robert H. asked
I have a GE Monogram dishwasher model # XXXXX. It makes a loud noise at the end of the cleaning cycle before the heat cycle, which lasts for 3 seconds, stops, and then starts again. The noise is not consistent, and it stops when I open the door. The dishwasher cleans fine, but I'm concerned about the noise. What could be causing this and how can I fix it?
May 29th, 2023
Kenneth G. answered
The loud noise you're hearing is likely due to an issue with the drying fan in your dishwasher, whic...
May 29th, 2023
Create an account to view answers and interact with the community!
I have a GE Profile PSC25MSSA SS refrigerator. The temperature in the fresh food department is 44-50 degrees, while the freezer is fine at 0-10 degrees. I have replaced the main control board, defrost limiter thermostat, and temperature sensors (3). The evaporator fans in both the fresh food and freezer departments are running, and the fan and compressor on the back of the refrigerator are working fine. There is no built-up frost on any of the evaporators. What could be causing the temperature issue in the fresh food department?
February 4th, 2024
I have an LG Fuzzy Logic WF-T8016TP washing machine that stopped working after a power surge. It gets stuck during the rinse cycle and won't empty. What could be the issue, and how can I fix it?
December 21st, 2024
My GE Profile electric dryer has a selection dial that just spins and I can't set it for any cycles. Can I replace the dial or is the problem more involved? Please advise.
November 21st, 2023
Why does my Maytag dishwasher (model DWU6702AAM) emit a bad odor when it's not in use?
September 5th, 2024
I am fixing a Victory refrigerator with a compressor that turns on and off every 3-4 minutes, and the temperature won't cool down. The previous technician added a 3 in 1 starter kit, and the pressure is 40 psi low side and 200 psi high side. The compressor terminal has continuity, and there are no low or high pressure switches. The condenser coil, condenser fan, and evaporator fan are all working. What could be causing this issue, and what steps should I take to diagnose and fix it?
December 11th, 2024
