Amanda G. asked

🔌  Appliance

I have a Kenmore gas range with a digital control panel. While wiping it down, everything went off and nothing works. Is there a way to reset it?

August 4th, 2023

Lisa R. answered

The issue might be due to moisture getting into the electronics and shorting them out. Here are some...

August 4th, 2023

Sign Up to View Full Expert Answers

Create an account to view answers and interact with the community!

Sign Up with Email

🔌Related Questions

I replaced the motor and element in my dryer, tested the switches, and power is available and comes on. However, when I press the start button, nothing happens for 3-4 seconds, then there's a click like a relay. The dryer stopped working, and I found the element was half bad and the motor had an electrical burn smell. I ordered and installed both parts, and tested the door switch, but it seems everything works except the start button. What could be the issue, and what should I check next?

December 3rd, 2023

We accidentally pressed the lock button on our Maytag oven's digital panel and now it won't unlock. The lock icon disappears after holding the lock/unlock button for 3 seconds, but the door remains locked. How can we unlock the oven door?

December 2nd, 2023

I have a GE Side By Side Profile Artica Refrigerator with a non-working in-door water dispenser. The ice dispenser is functioning correctly. How can I troubleshoot and fix this issue?

March 31st, 2024

My GE dryer (model dsxh47eg1ww) will not run, and the 'clean lint filter' light is on (solid green). I have cleaned lint from everywhere, have electricity, but the unit will not run. The 'clean lint filter' light won't clear, and the unit beeps with all LEDs flashing, while the 'clean lint filter' LED stays lit steadily. Where is this sensor located, and can I bypass it to check the issue?

September 27th, 2023

I have a Frigidaire side-by-side refrigerator with a fountain that is only dispensing crushed ice, but the customer wants cubed ice. The solenoid tested good, and the actuator popped when 120 VAC was applied. What could be causing this issue, and what steps should I take to troubleshoot and fix it?

May 23rd, 2024